E3 Light Bracket - Medium
These E3 tail light brackets are made in Portland, using lasers! They are cut from 5052 aluminium and then anodized. They are designed for E3 tail lights originally - the notch in the bracket allows for the wire to be moved from bike to bike or to another position without having to rewire the entire system. We've found that they are compatible with other lights or mounts that use a 50mm center to center spacing between bolt holes. Upper holes (for mount) use M4 bolt, lower hole (for rack or frame) uses M5 sizing.
This design was made to attach to a rack, seat stay braze-ons, or dropouts braze-ons.
15cm long and 6cm wide. Light and mount not included.
I used this to attach a tail light to the Camper rack using the female coupling on the rear of the rack. Works perfectly.
As I purchased the bracket for a non- Velo Orange rack, I had to drill out the mounting holes to enlarge them for the bolt size on my electra ticino rack...once that was done, the bracket worked like one would expect it to...once mounted, you just forget about it. No issues whatsoever.
Great for adapting single hole bracket mount to 50mm spacing which came with my rear rack, swapped it out. I would say it is a Versatile nice little Bracket..........! Actually drilled another hole to set it back flush with the edge of the rear rack, you could probably make your own, but this truly the way to go, worked perfect for my applcation...............Quality Build!!! Would again........Thx!